* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 25권 / 6호
ㆍ저자명 : 김병삼, 김우진
ㆍ저자명 : 김병삼, 김우진
영어 초록
Internal combustion engine is the main source of environmental pollutants and therefore advanced technology is required to reduce harmful elements from the exhaust gases all over the world. Especially, when the exhaust gas is released from the automotive muffler, exhaust noise has many bad influence on the surrounding environment. In order to reduce the exhaust noise, it is necessary that automotive muffler must be designed for best exhaust efficiency. The sound insulation room was installed for the analysis of an acoustics characteristics of the noise from automotive muffler, in this study. Exhaust gas noise, noise distribution characteristics, pressure and temperature of exhaust gas were investigated with the change of annulus temperature of air cooled annulus automotive muffler and cooled annulus automotive muffler. The following results were obtained with this study. From the frequency analysis of automotive muffler, high noise distribution was observed in the range 100~2000Hz. It means that the noise in this range has an dominate influence for the overall noise. Noise reduction of automotive muffler was affected by the temperature of annulus. It is caused the result that the high temperature and pressure of exhaust gas are changed lower by the drop of annulus temperature. The tendencies of noise, the temperature and pressure of exhaust gas are similar to the performance curve of engine. Exhaust gas pressure is determined by the r.p.m. of engine and affected by the cooling performance of automotive muffler.참고 자료
없음"한국기계기술학회지"의 다른 논문
- 판지 자동 접착 및 접힘 가공기 개발5페이지
- 마찰교반용접시 Al 6061의 파괴인성의 평가에관한 연구5페이지
- 조리 중 발생하는 미세먼지를 감소시키기 위한조리장치의 실험적 연구6페이지
- 이동형 양불 판정 시스템 개발5페이지
- 소형 전기 트럭용 경량 적재함 후면 도어의 개발6페이지
- 국내 온실 난방부하 산정을 위한 난방적산온도의 비교분석 및 공간보간법을 이용한 지역별 제시14페이지
- 수소연료전지차 글로벌 자동차 제조사들의 기술경쟁력7페이지
- LED를 이용한 플렉시글라스 사인 흡진장치기술6페이지
- 실 주행 기반 화물차 무게중심 측정 방법 연구4페이지
- Ti-6Al-4V 합금의 레이저 용접성에 관한 기초 연구(Part I : 레이저 출력, 용접 속도의..7페이지